Interesting Research on – What No One Ever Told You

How Can You Replace a Cutlass Bearing?

The drive shaft log of any vessel has cutlass bearing which is made with brass and a grooved lining from the inside and which is lubricated by the water that penetrates the grooves when it is rotating, this.

It does not matter the number of times that you use your boat, but you must at some point change the cutlass bearing. When the time is up for changing the cutlass bearing, you will locate it a little off the keel or underneath the woodwork of the boat.

Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. Keep reading this article to know how to replace a cutlass bearing, now.

Prior to doing anything else, you should first locate the set screws so that you can remove them. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Always remember that set screws are not used by all boat manufacturers. If you know that set screws are not existing, then it is no use wasting time looking for them.

During a cutlass bearing replacement you will be required to cut the bearing. You can cut the cutlass bearing using a hacksaw if you don’t have a Sawzall from Propeller Depot with you. Using the Sawzall tool is something that requires you to have enough experience on how to use it.

Now to remove the cutlass bearing by bending it. You can bend the cutlass bearing to the inner side using a cold chisel and a hammer so that you reach the other side where you have made a cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.

Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. If you do so, you risk damaging the inside of the strut.

Finally, remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. Install a new cutlass bearing after you clean the strut’s surface. After removing the old cutlass bearing, and the surface of the strut is clean, and you are about to install a new cutlass bearing bought from Propeller Depot ensure the cutlass bearing can enter the acme props in a straight line.

If the ramrod strut is forced and not straight it, you may damage it. For it to go straight use grease on the washers of the cutlass bearing so that it can slide in the strut easily.

Suggested Post: you can look here